![]() Flip the material over and apply medium pressure with the iron to the back of the design for an additional 15 seconds.Apply medium pressure with the iron for 50 seconds. Place the weeded image, liner side up, onto the preheated material. ![]() Use the iron to preheat the area of the material in which you will be applying your cut image for 15 seconds.Make sure the steam setting is OFF for steam irons. Using the weeding tool found in the Cricut Tool Kit can make this process faster and easier. Remove negative Cricut iron-on film, leaving only the desired cut image on the liner (this process is known as weeding). ![]() Use the Cricut Heat Guide for recommended EasyPress settings. Note: These instructions are for using an iron with Patterned iron-on. Tip: To ensure best results, test a piece of Cricut Iron-on in an inconspicuous part of the item prior to application.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |